Table Of Contents
- Installing the Virtual Machine
- How to use Poky
- How to customize u-boot
- How to customize the Linux Kernel
- How to create the SD card
- How to write the NAND memory
- How to use HOB
- How to configure Minicom
- How to write a software application for the Pengwyn board
- Qt SDK
- Hardware
- Opkg Basics
- How to add 3”5 display with touch screen
HardwareΒΆ
Jumper settings
| boot sequence | ||||||
|---|---|---|---|---|---|---|
| J1 | J2 | J3 | 1st | 2nd | 3rd | 4th |
| open | open | open | MMC0 | SPI0 | UART0 | USB0 |
| open | open | close | EMAC1 | MMC0 | XIP MUX2 | NAND |
| open | close | open | Fast ext | EMAC1 | UART0 | Reserved |
| open | close | close | UART0 | EMAC1 | Reserved | Reserved |
| close | open | open | NAND | NANDI2C | MMC0 | UART0 |
| close | open | close | UART0 | SPI0 | XIP MUX2 | MMC0 |
| close | close | open | XIP MUX2 | UART0 | SPI0 | MMC0 |
| close | close | close | USB0 | NAND | SPI0 | MMC0 |
The hardware documentation of Pengwyn can be found here:
http://downloads.architechboards.com/doc/Pengwyn/download.html